A tiny bit of work on the mk1 today , first was to wrap the rear part of the loom with new loom tape and then throw it at the car.
It rings along the passenger side floor but at the rear seat area the factory fitment is inboard of the wheel tub and up the flimsy plate and continues to the boot where it clips to a strip along time boot edge. I couldn't do that as the fold down seats so my best plan is the send it thru the back door card panel hidden under the seat and run it over the tub to the back panel.

I drilled a 21mm hole (size holesaw I had at hand) so that a bung can be installed to stop wires getting cut on the edge, the bung will be printed in TPU .


Next will be the middle dash loom part which will join the front and rear together. I still need to create a mounting for the fuse board which could also be a 3d printed/designed item..

glad today is more civilized.
Last night was up there too.
We had been getting ash over the past week as the otway fires get closer.