Go back to home


We have detected that you are using ad blocking software.
The Classic Ford forum is made possible by ad revenue.
Please disable your ad blocker to ensure that this site lives on.

Hot!Alernative to Ryco A61 air filter element

Author
Post
Essentials Only Full Version
GTV6
Master
  • Total Posts : 706
  • Scores: 29
  • Reward points: 4665
  • Joined: 2011/08/01 11:02:49
  • Location: Perth WA Australia
  • Status: offline
2020/09/13 21:58:54 (permalink)
0

Alernative to Ryco A61 air filter element

Hi Guys
Has anyone tried the Ryco A88 in an original air filter.  Its only 3mm higher than the A61 but I am wondering if 3mm is going to be 3mm too much.  Other than that, ID is the same and OD is 1mm smaller which wont matter.  I would be surprised if 3mm mattered but thought I would ask.  Thanks.
post edited by GTV6 - 2020/09/13 22:16:13
#1


2 Replies Related Threads
    BEEVEE
    Aficionado
    • Total Posts : 903
    • Scores: 3
    • Reward points: 2771
    • Joined: 2014/01/02 15:53:02
    • Location: MORNINGTON PENINSULA, melbourne
    • Status: offline
    Re: Alernative to Ryco A61 air filter element 2020/09/13 23:41:31 (permalink)
    0
    From memory, using the A88 would mean the 2 bolts holding top lid down would need to be left 3mm of thread loose, as they normally bear down all the way "home" and tighten themselves at the end of travel. Not acceptable.
    The problem can be solved by adding 3mm Spacer or washers to the 2 hold down bolts threads and all will be well, otherwise the filter will be crushed/distorted with the result that dirty air might "slip past" where sealing is compromised.

    "GOOD BETTER BEST: NEVER LET IT REST: UNTIL YOUR GOOD IS BETTER, AND YOUR BETTER, BEST"
    ( Furphy WW1 HORSE-DRAWN water-tank end-plates)
    #2
    GTV6
    Master
    • Total Posts : 706
    • Scores: 29
    • Reward points: 4665
    • Joined: 2011/08/01 11:02:49
    • Location: Perth WA Australia
    • Status: offline
    Re: Alernative to Ryco A61 air filter element 2021/04/28 19:28:51 (permalink)
    0
    So I gave the Wesfil WA087 a try.  It fits really snug but the extra 2mm in height is noticeable if you look really close, but would not affect performance.  The A88 would be 1mm higher.  Wesfil also have the WA350 which is same height as the A61 but its ID is larger so it may not be as snug.  I will give it a try next time but for now at $14 I'm happy with the WA087. 
     
    For those in WA, Filter Discounters had the best price.
     

    Attached Image(s)

    #3

    Jump to:

    © 2021 APG vNext Commercial Version 5.1