Go back to home


We have detected that you are using ad blocking software.
The Classic Ford forum is made possible by ad revenue.
Please disable your ad blocker to ensure that this site lives on.

Hot!3D Printing Parts

Page: < 123 Showing page 3 of 3 - Powered by APG vNext Trial
Author
Post
Essentials Only Full Version
martymexico
Deity
  • Total Posts : 1878
  • Scores: 110
  • Reward points: 4971
  • Joined: 2011/08/01 11:02:49
  • Location: Adelaide Sth Aust Australia
  • Status: offline
Re: 3D Printing Parts 2023/06/21 12:15:09 (permalink)
0
A,hemm.. eBayexpress !!
Only cause I got ebuy plus and saved $135 ..
No rush Deano, I haven't built the cubical printer yet
#31
deano
Deity
  • Total Posts : 1142
  • Scores: 128
  • Reward points: 3114
  • Joined: 2015/08/19 10:49:10
  • Status: offline
Re: 3D Printing Parts 2023/06/23 13:41:52 (permalink)
0
was it Drewdog that was wanting these printed?:
 
Not mine, taken from a UK FB group and selling for about 15 pounds a set of 3.
 
Look like the only concern again is the filament used.
I think creep from  the heat would be an eventual problem though with alot of common filament.
 

Attached Image(s)

#32
Drewdog
Deity
  • Total Posts : 945
  • Scores: 77
  • Reward points: 4672
  • Joined: 2013/03/06 22:31:01
  • Status: offline
Re: 3D Printing Parts 2023/06/24 14:54:32 (permalink)
0
Thats the one Deano, the middle, double ones are hard to find, wonder if he has the outside single ones too.
Good to see someone doing them, guess I'll just put my originals on my spare, numbers match engine for another day.

GT Cortina Project "The Ugly Duckling"
#33

Page: < 123 Showing page 3 of 3 - Powered by APG vNext Trial
Jump to:

© 2023 APG vNext Trial Version 5.1