Go back to home

Accelerator cable

Author
Post
Essentials Only Full Version
Daaanniel
Enthusiast
  • Total Posts : 3
  • Scores: 0
  • Reward points: 3
  • Joined: 2015/05/28 11:12:33
  • Status: offline
2015/05/28 11:17:39 (permalink)
0

Accelerator cable

So I'm in the process of putting a Pinto 2l into my 1979 mk2 and I'm having troubles with connecting the accelerator cable to the accelerator cable bracket and I was just wondering if anyone could help me out with some photos on how it's ment to look like.
Thanks
#1


4 Replies Related Threads
    JVC063
    Aficionado
    • Total Posts : 105
    • Scores: 9
    • Reward points: 4920
    • Joined: 2011/08/01 11:02:49
    • Location: Balgownie NSW Australia
    • Status: offline
    Re: Accelerator cable 2015/05/28 13:58:47 (permalink)
    0
    No photo, however if its all factory, you will have a bracket mounted to the inlet manifold with two bolts at 90 degrees to carbie. The cable goes through the square section and is held by pushing the clip in to expand it. The cable then attaches to the ball, slide the clip up the cable then push over ball sliding the clip back over to secure.
    #2
    Daaanniel
    Enthusiast
    • Total Posts : 3
    • Scores: 0
    • Reward points: 3
    • Joined: 2015/05/28 11:12:33
    • Status: offline
    Re: Accelerator cable 2015/05/28 17:34:50 (permalink)
    0
    Okay I kinda understand you. With the photos I sent do u need the steel rod that comes off the bracket? And also which holes where u referring too? Thanks for ur quick reply 😀

    Attached Image(s)

    #3

    JVC063
    Aficionado
    • Total Posts : 105
    • Scores: 9
    • Reward points: 4920
    • Joined: 2011/08/01 11:02:49
    • Location: Balgownie NSW Australia
    • Status: offline
    Re: Accelerator cable 2015/05/29 07:19:00 (permalink)
    0
    Yes,
    The rod still has the clip on the ball end. The way it is pictured is the correct orientation. the other end that goes on the carbie pushes in from the side towards the cam cover. Useually use a long screw driver between the manifold and rod to assist installation.
    #4
    Daaanniel
    Enthusiast
    • Total Posts : 3
    • Scores: 0
    • Reward points: 3
    • Joined: 2015/05/28 11:12:33
    • Status: offline
    Re: Accelerator cable 2015/05/29 19:28:02 (permalink)
    0
    Thanks heaps I'll try to work it out 😀
    #5
    Jump to:
    © 2025 APG vNext Trial Version 5.1