Go back to home

Rear Axel Bearing Width

Author
Post
Essentials Only Full Version
2Mk2
Enthusiast
  • Total Posts : 53
  • Scores: 3
  • Reward points: 3776
  • Joined: 2011/08/01 11:02:49
  • Location: Melbourne Victoria Australia
  • Status: offline
2013/11/06 18:29:14 (permalink)
0

Rear Axel Bearing Width

I had some new bearings pressed onto the axles of a standard diff (banjo) from an Escort Mk2 2.0ltr. When fitting the axles I noticed that the bearings were not fully flush with the end of the axle housing. I measured the width of the bearings and they came to about 22mm. The recess at the end of axle housing is about 18mm. I'd like to confirm the exact bearing width before going back for another try. I've looked up workshop manuals etc but can't seem to find any reference to bearing width. Any help appreciated.
 
Cheers,
Adil
 

Mk2 RS2000 4 Door
Mk2 RS2000 2 Door - Project
Mk2 Focus RS - Daily
#1


2 Replies Related Threads
    SFE
    Aficionado
    • Total Posts : 199
    • Scores: 7
    • Reward points: 5071
    • Joined: 2011/08/01 11:02:49
    • Location: melbourne vic Australia
    • Status: offline
    Re: Rear Axel Bearing Width 2013/11/06 22:57:44 (permalink)
    0
    My SKF bearings measure closer to 21mm. Remember there's the width of the brake drum backing plate to add to the depth of the recess, which is also held in place by the retaining plate.
     
    rgds,
    SFE
    #2
    2Mk2
    Enthusiast
    • Total Posts : 53
    • Scores: 3
    • Reward points: 3776
    • Joined: 2011/08/01 11:02:49
    • Location: Melbourne Victoria Australia
    • Status: offline
    Re: Rear Axel Bearing Width 2013/11/09 23:43:30 (permalink)
    0
    Thanks for the reply. I'll measure it up again with the backing plate.
     
    cheers,
     
    Adil

    Mk2 RS2000 4 Door
    Mk2 RS2000 2 Door - Project
    Mk2 Focus RS - Daily
    #3

    Jump to:
    © 2025 APG vNext Trial Version 5.1