Powered by APG vNext Trial - valve clearances with 234 cam

Forgot Your Password? Forgot your Username? Haven't received registration validation E-mail?

Author Post Essentials Only Full Version
ratta tat tat Supporter Total Posts : 1633 Scores: 39 Reward points: 5492 Joined: 2011/08/01 11:02:49 Location: Brisbane Status: offline 2012/04/16 01:11:05 (permalink) 0 valve clearances with 234 cam Hello Are there specific clearances for the 234 cam or should factory clearances be set? Thanks post edited by ratta tat tat - 2012/04/16 01:16:40 #1 2 Replies Related Threads
Batman105E Enthusiast Total Posts : 20 Scores: 0 Reward points: 1249 Joined: 2011/08/01 11:02:49 Location: Ballarat Victoria Australia Status: offline Re:valve clearances with 234 cam 2012/04/16 07:27:56 (permalink) 0 Check the kent cams website I am sure they have the settings there. From the website it shows VC 0.56mm Inlet 0.61mm Exhaust #2
ratta tat tat Supporter Total Posts : 1633 Scores: 39 Reward points: 5492 Joined: 2011/08/01 11:02:49 Location: Brisbane Status: offline Re:valve clearances with 234 cam 2012/04/27 23:02:41 (permalink) 0 Cheers batman They've been set hot now so all good. I didn't know what to expect with this cam but it has made a difference, I notice the torque a lot. Churns the rears no problems at all :) Pulls well in 2nd gear. I'll be trying out some bigger jets soon, i have a gut feeling the idle jets might be lean. #3

Jump to:

valve clearances with 234 cam