Go back to home

cam seal

Author
Post
Essentials Only Full Version
dnorris
Enthusiast
  • Total Posts : 67
  • Scores: 0
  • Reward points: 1998
  • Joined: 2011/08/01 11:02:49
  • Location: Adelaide Sth Australia
  • Status: offline
2010/07/02 08:31:08 (permalink)
0

cam seal

Just wondering if the special tools are still available, to remove the front oil seal on (cylinder head) of a 2.0 pinto mtr,or is there another method.

The tc/td workshop manual list the special tool numbers as 21-008 and 21-009 and AG-6250 for the cam shaft bearing remover and installer

any help would be greatly appreiciated

regards Norris [?]
#1


5 Replies Related Threads
    2lt_Scort
    Supporter
    • Total Posts : 1285
    • Scores: 23
    • Reward points: 5188
    • Joined: 2011/08/01 11:02:49
    • Location: Adelaide Australia
    • Status: offline
    RE: cam seal 2010/07/02 08:51:43 (permalink)
    0
    G'Day Norris,

    From memory a large socket should do the job.

    Rhys
    #2
    Sterling
    Scholar
    • Total Posts : 1060
    • Scores: 0
    • Reward points: 663
    • Joined: 2011/08/01 11:02:49
    • Location: Flinders VIC Australia
    • Status: offline
    RE: cam seal 2010/07/02 11:18:31 (permalink)
    0
    hammer and a screwdriver? tap it to the side then pull it out by hand.
    #3

    dnorris
    Enthusiast
    • Total Posts : 67
    • Scores: 0
    • Reward points: 1998
    • Joined: 2011/08/01 11:02:49
    • Location: Adelaide Sth Australia
    • Status: offline
    RE: cam seal 2010/07/02 13:20:02 (permalink)
    0
    thanks for the help
    #4
    loomer
    Enthusiast
    • Total Posts : 64
    • Scores: -1
    • Reward points: 2823
    • Joined: 2011/08/01 11:02:49
    • Location: Adelaide SA Australia
    • Status: offline
    RE: cam seal 2017/10/29 08:48:32 (permalink)
    0
    Can this be done without taking the head off ?
     
    #5
    Chuff
    Aficionado
    • Total Posts : 145
    • Scores: 12
    • Reward points: 5593
    • Joined: 2011/08/01 11:02:49
    • Location: VICTORIA Australia
    • Status: offline
    RE: cam seal 2017/10/29 17:02:49 (permalink)
    0
    Yeh, just screw it.
     
    https://www.youtube.com/watch?v=Ehqz1Y-ggGo
     
    #6

    Jump to:
    © 2025 APG vNext Trial Version 5.1