Go back to home

Do any parts fron the KA fit the Kent X-flow?

Author
Post
Essentials Only Full Version
gtv6capri
Deity
  • Total Posts : 1461
  • Scores: 53
  • Reward points: 5548
  • Joined: 2011/08/01 11:02:49
  • Location: Melbourne Vic Australia
  • Status: offline
2010/01/17 16:46:31 (permalink)
0

Do any parts fron the KA fit the Kent X-flow?

At the local wreckers I saw a Ford KA. On looking into the engine bay the "Endura" 1.3 motor looks a LOT like a kent X-flow. It has throttle body injection and electronic ignition. Are the parts from these engines interchangable?
#1


3 Replies Related Threads
    digginganddirt
    Enthusiast
    • Total Posts : 215
    • Scores: 0
    • Reward points: 1801
    • Joined: 2011/08/01 11:02:49
    • Location: bendigo victoria Australia
    • Status: offline
    RE: Do any parts fron the KA fit the Kent X-flow? 2010/01/17 20:24:09 (permalink)
    0
    that would be pretty sweet, ut surly someone would of though of this allready?
    #2
    Avon
    Enthusiast
    • Total Posts : 255
    • Scores: 1
    • Reward points: 2799
    • Joined: 2011/08/01 11:02:49
    • Location: Perth WA Australia
    • Status: offline
    RE: Do any parts fron the KA fit the Kent X-flow? 2010/01/17 23:49:23 (permalink)
    0
    No they are a different engine. Nothing fits (apparently)
    #3

    cosworthfreak
    Moderator
    • Total Posts : 684
    • Scores: 53
    • Reward points: 5517
    • Joined: 2011/08/01 11:02:49
    • Location: Location
    • Status: offline
    RE: Do any parts fron the KA fit the Kent X-flow? 2010/01/27 00:17:52 (permalink)
    0
    From Burtons page on crossflows, "The final versions, OHV, HCS and Endura are similar but shorter versions and share very few if any inter-changeable parts and reverted back to the original pre-X/flow design of a three bearing crank."

    http://burtonpower.com/technical_1/kent_crossflow.aspx
    #4
    Jump to:
    © 2025 APG vNext Trial Version 5.1