Go back to home

Input shaft to bellhousing measurement

Author
Post
Essentials Only Full Version
Suttonmotorsport
Aficionado
  • Total Posts : 242
  • Scores: 6
  • Reward points: 4295
  • Joined: 2011/08/01 11:02:49
  • Location: Traralgon Victoria Australia
  • Status: offline
2013/08/12 09:23:43 (permalink)
0

Input shaft to bellhousing measurement

Hi All,
As the title suggests, I am looking for the distance from the face of the bellhousing to the tip of the input shaft.
I dont know if it is flush or if it's below the bellhousing or protrudes past the bellhousing.
 
Cheers
Craig

Suttonmotorsport
#1


1 Reply Related Threads
    Jason
    Enthusiast
    • Total Posts : 90
    • Scores: 1
    • Reward points: 6114
    • Joined: 2011/08/01 11:02:49
    • Location: Caloundra Queensland Australia
    • Status: offline
    Re: Input shaft to bellhousing measurement 2013/08/20 12:15:08 (permalink)
    0
    On my type 9 g'box, the tip of the input shaft is 0.6mm inside the face of the bellhousing.
    I'd imagine a 4 speed box would be about the same, but I can't confirm that as i don't have one to measure.
     
    Cheers, Jason.
     
     
    #2
    Jump to:
    © 2025 APG vNext Trial Version 5.1