How do I lower Master Cylinder Bracket?

All the pros use a FBH. But I think cut & weld would be a better option if you have the know how. Be wary of the changes to rod alignment when the bracket drops. Keep us posted, I haven't seen or heard results from this mod before :)

Thanks Martymexico
That was an option that ran through my mind.
My only concern from that was if the fluid reservoir would then not be level, and whether there might be some adverse effects from that.  I then thought this could be offset by putting shims under the bottom 2 bolts of the vacuum servo where it bolts to the bracket.
Hence why I was hoping to hear from someone who had done it, so I am not the guinea pig!! lol.
Have you done the mod martymexico?
cheers