Go back to home

thermostat (heater hose connector)

Author
Post
Essentials Only Full Version
dnorris
Enthusiast
  • Total Posts : 67
  • Scores: 0
  • Reward points: 1998
  • Joined: 2011/08/01 11:02:49
  • Location: Adelaide Sth Australia
  • Status: offline
2010/08/29 08:28:24 (permalink)
0

thermostat (heater hose connector)

just wondering if theres a replacement part for the heater hose to connect on to the thermostat housing its a small water nipple,i need one please.
thank you Norris
#1


5 Replies Related Threads
    PeterM
    Master
    • Total Posts : 933
    • Scores: 34
    • Reward points: 4984
    • Joined: 2011/08/01 11:02:49
    • Status: offline
    RE: thermostat (heater hose connector) 2010/08/29 18:58:51 (permalink)
    0
    Which engine??
    #2
    dnorris
    Enthusiast
    • Total Posts : 67
    • Scores: 0
    • Reward points: 1998
    • Joined: 2011/08/01 11:02:49
    • Location: Adelaide Sth Australia
    • Status: offline
    RE: thermostat (heater hose connector) 2010/08/29 19:13:47 (permalink)
    0
    sorry 2.0 litre pinto
    #3

    grant
    Supporter
    • Total Posts : 363
    • Scores: 2
    • Reward points: 4811
    • Joined: 2011/08/01 11:02:49
    • Location: Brisbane Qld Australia
    • Status: offline
    RE: thermostat (heater hose connector) 2010/08/29 19:51:45 (permalink)
    0
    shouldnt connect to the tstat housing.

    Water pump and intake manifold.

    Temp guage can go in the bit your talking about i think?

    photo?
    #4
    premacist
    Enthusiast
    • Total Posts : 100
    • Scores: 0
    • Reward points: 1213
    • Joined: 2011/08/01 11:02:49
    • Location: New Zealand
    • Status: offline
    RE: thermostat (heater hose connector) 2010/09/09 14:39:26 (permalink)
    0
    you could make an adaptor that fits between the thermostat and the head and fit a hose fitting on it... make shore the Radiator is higher that than the thermostat housing
    #5
    dnorris
    Enthusiast
    • Total Posts : 67
    • Scores: 0
    • Reward points: 1998
    • Joined: 2011/08/01 11:02:49
    • Location: Adelaide Sth Australia
    • Status: offline
    RE: thermostat (heater hose connector) 2010/12/09 08:20:40 (permalink)
    0
    After lots of looking aroung ive found something that fits its a air line fitting external thread with a male barbed end. The barbed end is too small for the heater hose so back to sq 1 and keep on lookin
    #6

    Jump to:
    © 2025 APG vNext Trial Version 5.1