Go back to home

Rear Spoiler, RS 2000 badge

Author
Post
Essentials Only Full Version
RS 2000
Deity
  • Total Posts : 536
  • Scores: 51
  • Reward points: 6199
  • Joined: 2011/08/01 11:02:49
  • Location: South Australia
  • Status: offline
2010/08/19 01:37:29 (permalink)
0

Rear Spoiler, RS 2000 badge

Hi
Just wandering if anyone has measurements for drilling 4 holes in mk 2 Escort bootlid to fit the bootlid spoiler? Or if someone could measure theirs? Even if it is just one of the end holes with measurements from edges of the bootlid.

Also I am chasing RS2000 nose cone FORD badge/lettering. These are individual F O R D letters as per German RS2000 Escorts. Each letter is held in by 2 pins.

Thanks
#1


3 Replies Related Threads
    Jaycees
    Aficionado
    • Total Posts : 400
    • Scores: 7
    • Reward points: 4432
    • Joined: 2011/08/01 11:02:49
    • Location: Windsor nsw Australia
    • Status: offline
    RE: Rear Spoiler, RS 2000 badge 2010/08/19 09:04:08 (permalink)
    0
    Hi there,

    OK

    The 2 holes to the outside are 152mm up from the bottom edge of the

    boot and the 2 centre holes are 155mm up from the bottom boot edge,

    N/S hole is 92mm in from side

    O/S hole is 91mm in from side

    N/S inner hole is 492mm in from side

    O/S inner hole is 491mm in from side

    They are approx. 1/4 inch holes drilled

    I just measured this now off a factory boot with holes

    I think you would get away with drilling the holes all at either 152

    or 155mm as it is not an issue

    Jim
    #2
    RS 2000
    Deity
    • Total Posts : 536
    • Scores: 51
    • Reward points: 6199
    • Joined: 2011/08/01 11:02:49
    • Location: South Australia
    • Status: offline
    RE: Rear Spoiler, RS 2000 badge 2010/08/19 22:41:07 (permalink)
    0
    Thanks for that Jim, super fast reply!

    Still after that nose cone badge/letterset.I have emailed a few places in UK about it, if anyone has any suggestions where to try would be much appreciated.

    Cheers



    #3

    RS 2000
    Deity
    • Total Posts : 536
    • Scores: 51
    • Reward points: 6199
    • Joined: 2011/08/01 11:02:49
    • Location: South Australia
    • Status: offline
    RE: Rear Spoiler, RS 2000 badge 2010/08/20 02:21:05 (permalink)
    0
    The measurements worked out good but just a little correction the N/S and O/S holes are 192mm and 191mm from side.(and no I didn't get cought out)

    Cheers
    #4
    Jump to:
    © 2025 APG vNext Trial Version 5.1