ATS 6 puck unsprung & lightened flywheel problem

Re: ATS 6 puck unsprung & lightened flywheel problem (beagle_senior)

Mon, 25 Mar 2013 07:04:04 GMT

sweet good to know mate thanks for the info

Re: ATS 6 puck unsprung & lightened flywheel problem (zvargulis)

Sun, 24 Mar 2013 21:41:46 GMT

adjusted the clutch pedal all good.

Re: ATS 6 puck unsprung & lightened flywheel problem (beagle_senior)

Sat, 23 Mar 2013 21:16:08 GMT

not sure mate, I havent taken the box back off yet to check, and really dont want to...

Maybe someone else might know, I was just going to see if the push rod made a difference and go from there...

link to them is here ---> http://speed-source.net/?...tascion-clutch-pushrod

Re: ATS 6 puck unsprung & lightened flywheel problem (zvargulis)

Sat, 23 Mar 2013 21:12:13 GMT

do you know if the pivot point in the middle of the fork is adjustable?

Re: ATS 6 puck unsprung & lightened flywheel problem (beagle_senior)

Sat, 23 Mar 2013 21:08:17 GMT

I have the same problem as you atm mate. However, I have sitting around somewhere the extended slave cylinder push rod which, when I find it will install and see if thats any better.

I am running an RPS sprung 6 puck clutch with alloy flywheel, all new though..

ATS 6 puck unsprung & lightened flywheel problem (zvargulis)

Sat, 23 Mar 2013 20:53:38 GMT

I have just finished putting a ats 6puck unsprung clutch in and a light weight flywheel, i have a problem where the clutch will not disengage.

I know i installed everything correctly, 99% sure because i triple check everything.

With the engine off i can cycle through all gears,
With the engine on i cannot select a gear,
I can start the car in gear and it takes off.

Does anyone know if you have to adjust the pivot under the release fork?

I used the throwout bearing that was supplied with the clutch kit, the clutch plate is around the right way.

The flywheel in a 2nd hand though machined chromoly lightened flyweel purchase from road and track

there is a little squeak when i push the clutch pedal (noise comes from engine bay, i can see and feel the slave piston push the fork. The slave has no play in it and is installed correctly.

I am going to try and adjust the pedal tomorrow but if not i guess i have to pull the gearbox.

any ideas anyone?
Cheers.