Custom side feed inlet manifold with 80mm throttle body for GEN2 3SGTE

Re:Custom side feed inlet manifold with 80mm throttle body for GEN2 3SGTE (Admin)

Mon, 11 Feb 2013 22:06:59 GMT

If it is taller than a standard rail then I doubt it will fit.

Re:Custom side feed inlet manifold with 80mm throttle body for GEN2 3SGTE (JDM_GT)

Mon, 11 Feb 2013 20:57:35 GMT

i have a wolkats fuel rail and top feed 1000cc ID injectors so this prob wont fit then???

Re:Custom side feed inlet manifold with 80mm throttle body for GEN2 3SGTE (Admin)

Mon, 11 Feb 2013 19:56:43 GMT

It was made by Redneck MR2. It looks like the standard cable will fit easily.
It has never been used.
I can't use it because there isn't enough room to fit my top feed injectors and custom rail.
This will be able to produce big power - this won't be the limiting factor.
It looks like stainless steel though Redneck MR2 will be able to confirm.

Re:Custom side feed inlet manifold with 80mm throttle body for GEN2 3SGTE (JDM_GT)

Mon, 11 Feb 2013 18:30:29 GMT

can you still use the standard throttle cable on a mr2?? also what did it come off and why? what sort of power did the car make. and what is it made from??

Custom side feed inlet manifold with 80mm throttle body for GEN2 3SGTE (Admin)

Sun, 10 Feb 2013 22:07:53 GMT

http://cgi.ebay.com.au/ws/eBayISAPI.dll?ViewItem&item=230926979916