https://www.classic-ford.org/mr2/mr2play/tm.aspx?m=383(c) MR2 AUSTRALIA30yeah i have a earlier model. ill work it out i just wnated to know if you guys knew off the top of your head.https://www.classic-ford.org/mr2/mr2play/FindPost/386Fri, 29 Jul 2005 16:23:54 GMTyou have to look at your leads and we'll work it out. the late model caps are designed for a special small pin end. many aftermarket leads have the same size wire and push in connector, but just a fatter insulation. send me a clear picture of the lead where it pushes into the dissy cap. if the cap has a "latch" on it in that place, its designed for the small leads. We also stock the earlier cap which is easier to fit big leads into.https://www.classic-ford.org/mr2/mr2play/FindPost/385Fri, 29 Jul 2005 08:15:56 GMTare you able to use aftermarket ignition wires on these caps? such as a set of msd's or similar without having the same ends as what toyota uses.https://www.classic-ford.org/mr2/mr2play/FindPost/384Thu, 28 Jul 2005 18:02:54 GMTwe now have a limited supply of these hard-to-get parts. current prices are: cap $63.78 rotor arm $12.67. the Gen 3 cap is different to the early ones in that it uses the small diameter plug wires and has a tang to postively locate the plastic wire cover onto the cap. you cannot use a gen 2 cap with gen 3 wires. The rotor arm is the same Gen 2 & Gen 3.https://www.classic-ford.org/mr2/mr2play/FindPost/383Wed, 27 Jul 2005 13:15:11 GMT