RE: braided brakes hoses ADR approved (Road and Track)

Tue, 11 Sep 2007 18:41:19 GMT

yes, I can make them for AW11's but dont keep them on the shelf. there are 2 different lengths front & rear, so you have to get a tape measure and tell me what lengths you have. no hassles then.

RE: braided brakes hoses ADR approved (bustin)

Wed, 11 Jul 2007 18:59:07 GMT

Anything for the AW's?

RE: braided brakes hoses ADR approved (greddy_es)

Mon, 11 Jun 2007 22:34:11 GMT

Email sent :)

braided brakes hoses ADR approved (Road and Track)

Tue, 29 Aug 2006 12:25:13 GMT

we now stock a selection of Australian made, braided brake lines. These all have ADR7/00 compliance stamps on them and carry federal Govt DOTARS component registration# 30886, so there should be no hassles with any registration authority. At present we have stock of front 185 & 205 GT4 and all MR2 SW20 ones.
Note, the rear SW20 ones only have 1 hole where they bolt to the inner guard panel, not 2 like standard, but they fit OK.
Others can be made to order in a few days provided we have a sample. We are happy to organise them up for just about anything, provided we can get the relevant end fittings. Most common Japanese fittings are available.
All the ones in stock are $66 each including GST & post within australia. Most other hoses will be around this price.
While you are at it, check out our "lucas" pads for all models. These are very popular for occasional track day use as they have higher temp rating than commonly used bendix pads.