Will ST185 3s-gte leads fit a rev1 SW20?

Re: Will ST185 3s-gte leads fit a rev1 SW20? (just_ace)

Sat, 11 Jun 2016 00:54:21 GMT

No they dont interchange unless you also change the dizzy cap to suit.

Re: Will ST185 3s-gte leads fit a rev1 SW20? (antmcbane)

Fri, 10 Jun 2016 19:31:39 GMT

aw man I ended up buying the eagles over the ngks just because i wasn't too sure :/ - hopefully eagle quality isn't crap

Re: Will ST185 3s-gte leads fit a rev1 SW20? (Admin)

Fri, 10 Jun 2016 19:23:20 GMT

The differences are at the cap end over the years. I'm pretty sure that they all interchange anyway.

Re: Will ST185 3s-gte leads fit a rev1 SW20? (antmcbane)

Wed, 08 Jun 2016 17:56:29 GMT

Thanks man, that looks like the easiest way to do it. Was dead set on NGK but if I can't be sure I'm getting the right thing at least the eagles seem to be. Hopefully the quality is fine, reviews seem good (y)

Re: Will ST185 3s-gte leads fit a rev1 SW20? (just_ace)

Wed, 08 Jun 2016 16:49:38 GMT

http://m.ebay.com.au/itm/Ignition-Leads-for-Toyota-MR2-2-0L-SW20-3SGE-3SGTE-Turbo-Eagle-7-0mm-E74577-/140774401527?nav=SEARCH

Re: Will ST185 3s-gte leads fit a rev1 SW20? (just_ace)

Wed, 08 Jun 2016 16:45:59 GMT

The cap to plug leads wil be fine, but i think there is some difference in the cap to coil lead.

Re: Will ST185 3s-gte leads fit a rev1 SW20? (antmcbane)

Wed, 08 Jun 2016 12:52:25 GMT

Yep - exactly, and I'm correct in thinking that those listed "st185" leads will fit my sw20 as they are both 2nd gen 3s-gtes?

Re: Will ST185 3s-gte leads fit a rev1 SW20? (just_ace)

Wed, 08 Jun 2016 12:43:02 GMT

If you currently have 7mm push on leads then you need the same to replace.

The thinner ones are generally clip on at the dizzy cap.

Will ST185 3s-gte leads fit a rev1 SW20? (antmcbane)

Wed, 08 Jun 2016 11:10:33 GMT

Have a 1990 JDM 3s-gte MR2 all stock. Ignition leads have 7mm written on them - car has been running rough at low rpm when taking off and going up hills so I'm going to overhaul the ignition and fuel system.

When I use SCA's (don't judge) part finder it says I need the 5mm ones, but I'm gonna go with what's currently on the car I reckon. The problem is - I'm not sure if the ST185 celica's leads will fit or are the right ones:
http://www.ebay.com.au/it...cp=1&sojTags=bu=bu

Me thinking logically says they should be exactly the same with the only slight variation being the length of the ignition coil to distributor cable - Looking at the lengths on the SCA site it looks like the leads are about 1cm longer for the ST185 ones. If I buy the 5mm version I'm not sure I will have the right ones.

Anybody know for sure if those ones will work OK?

Cheers