Help... URGENT!

To Bottom

Help... URGENT! (p.62)
Post New Thread
Regular
krt10

1600 starter motor needed

hey guys. my starter died in the daily today. need a 1600 started asap in adelaide. can anyone help? thanks..
4
2012/01/15 11:01:34
escortking

escort diff centre

im after a escort diff centre asap car is a 2l but i dont really care what i get as long as it fits in sydney area thanks..

2012/01/14 17:56:36
ebokazion

escort panel van help

hi, if anyone could give me some advice it would be awesome! i have a 1979 escort panel van that i am rebuilding. i have all of the parts i need to come from a donor car (1980 escort sedan). i am about to start the process of swapping everything from the 1980into the Van. by everything i mena EVERYT..
6
2012/01/14 09:44:42
Luke

Self adhesive heat shield

As above where is the best place to get this from? Hopefully with out it costing a couple of hundred dollars for a square foot..
3
2012/01/13 22:03:02
mezza18

rs 765?

gday guys, just wondering if anyone from vic remembers or knows the where abouts of a red mk2 rs2000 with the plates rs765? it was my dads and he just wants to see if anyone knows of it or where it may be. He said when he got it in 1985 it had been modified heavily, fully worked motor, hotwires, low..

2012/01/11 20:18:41
smallvan

Problems with my weber dgva

As as mine is broken,it is throwing fuel down the guts like a top fuel motor. I have tried Carb cleaner, Smaller jets, Bigger jets, New needle and seat, Adjusted the flot to what the book says Put a new kit through it , and its still doing it Its flooding the 1600 motor, i have tried asking the carb..
5
2012/01/09 09:14:15
Luke

Cossie turbo ecu maps

Hi all has aynone got any maps there willing to share? Im running autronic smc. Phil, Mark..
11
2012/01/08 12:58:15
Matt75

What flares to use for brake lines?

Hi Guys, I am doing the plumbing on my diff and have a question about what are the best flares to use. In the picture below you can see the proffessional ones and my efforts. I am only able to do single, not double, flares as I don't have the tools. My question is will the single flare I have done..
5
2012/01/08 10:36:45
Matt75

Wanted urgently - Axle Flange Bolts

Hi Guys, I need 2 bolts (and the nuts) where the axle flange bolts to the axle housing. (See pic below) I have just finished rebuilding a diff and have been unsuccessful in tracking some down. I got 6 as part of the Paul Dunstan R31 Bracket kit (the bottom ones in the photo) but can't find more. I h..

2012/01/06 17:40:24
Mickos

Electronic ignition and old tacho

Hi all, I recently put in a under dizzy cap electronic ignition kit in a 1600xflow 78 model motor, it runs very well. The face on the tacho i had in the dash was buggered and wasn't going as i rewired the ignition for the 12v coil, I just replaced with one i got off ebay. I run the appropriate wires..
6
2012/01/06 16:43:47

<< ..61 62 63 .. - Powered by APG vNext Trial

© 2025 APG vNext Trial Version 5.1

Use My Existing Forum Account

Username: Password: Verification:

Use My Social Media Account