Help... URGENT!

To Bottom

Help... URGENT! (p.40)
Post New Thread
Regular
obsesscort

Running in procedure

Hey all i've searched all over for a thread that has some recommended tips on running in... can't seem to find it? Anyway, I've just had my mk2 with a rebuilt 2.0L in it dyno tuned and am ready to run in, could some one link me to the correct advice or provide their own run in procedure, shes a very..
11
2012/10/29 09:48:54
obsesscort

Connecting stock tacho

To connect a stock tachometer, what needs to be done? The harness that clips into the rear of the tacho doesn't seem to be working, can I bypass this by running wires from the appropriate connections? I am under the impression one should be to the - on the ignition coil... what else needs wiring (ot..
2
2012/10/26 08:58:42
obsesscort

What does the "tallest gear" refer to?

Sorry for a question that may seem obvious to some... but what does this refer to? first or fourth?..
5
2012/10/26 08:48:08
codename brenda

1600 radiator

Hello , what would be the best option for a bolt in radiator for a mildly worked 1600 in a 1300xl shell ?? any suggestions would be greatly appreciated.. Cheers...
3
2012/10/21 09:20:58
obsesscort

Deceleration valve

Hey guys, can these decel valves on the inlet manifold be done away with? Cheers..
4
2012/10/20 13:37:46
dnorris

4 Speed Gear Box

My 4 speed g/box has a gearbox oil leak im sure it from the front seal,i replaced the O ring some months ago are they hard to remove? ive ordered seals and gaskets from the U.K. do you have to have the gears removed and the seal pressed from the inside? Regards Norris..
2
2012/10/15 19:42:50
Acco

Anglia 105E camshaft oil seal

Does anyone know the correct camshaft oil seal size for a 105E anglia?..
2
2012/10/15 11:25:02
richo17

deciphering engine block number

hi all, just wondering if anyone is cluey with block numbers on xflows. i remember reading somewhere that there is a serial number on the block somewhere, and that certain numbers mean a thicker block? Cheers..

2012/10/13 16:57:12
obsesscort

Where to get your carby tuned for a 2.0L

Hey guys, anyone know of a good mob in the Newcastle NSW area? Got the pinto in and running but the carb tuning is all over the shop! Thanks in advance..

2012/10/13 16:35:07
Matt75

Sway Bar Mounting Bolt Thread Size - MK2

Hi Guys, Any one know the size as per above? I need some longer bolts as I am fitting an Anti - Dive Bar and the bolts I have are the wrong size. I could take the originals into a bolt shop but just thought someone may know. Cheers, Matt..
4
2012/10/10 21:49:58

<< ..40 41 42 .. - Powered by APG vNext Trial

© 2025 APG vNext Trial Version 5.1

Use My Existing Forum Account

Username: Password: Verification:

Use My Social Media Account