Help... URGENT!

To Bottom

Help... URGENT! (p.21)
Post New Thread
Regular
obsesscort

Can anyone tell me what this is???

Hey guys, I'm going to get my engine tuned and this little grommet thing that houses the carby accelerator actuator or whatever you may call it, has completely disintegrated... First problem is i don't know what to call it, which leads to my second problem, where do i get a new one :P Any..
4
2014/03/12 09:54:47
wade

Vaccume advance

Just wondering if I hooked up my vaccume advance direct to my inlet manifold would that be ok? Or too much vaccume?..
5
2014/03/12 09:45:00
75Van

There's a dolphin in my struts!!

Well that’s what it sounds like anyway! As I make low speed manoeuvres such as turning into a driveway the front drivers side of the van makes what could be described as a metallic ticking/grinding sound, kind of like a dolphin (a metallic dolphin). The problem is worse in reverse – quite a bit more..
5
2014/03/11 20:54:17
Cholaso

Crazy Tachometer

Hi I put an Rs dash in my mk2. It worked well for a year or so and then one day it went crazy. In idle its on zero but driving normally I.e cruising it reads 6000 rpm. Jyst wanna know if anyone has had same issue and if so how to fix it. NO I AM NOT DRIVING LIKE A FOOL Rodney..
1
2014/03/09 23:14:41
eamonlad

needed f11 emulsion tubes asap

anyone have a set of f11 emulsion tubes for my weber twin 40s or no were i can get my hands on some asap im in adelaide, thanks..

2014/02/28 23:20:33
GeeBeeN

RUST IN ALL THE USUAL PLACES

RUST IN ALL THE USUAL PLACES, Originating often from rust where we cannot see, do we need a Specific Thread where All of these usual places can be identified by experienced members of this Forum and Associated with solutions that have worked, or not worked, or still being evaluated. The proof of t..
5
2014/02/28 14:15:49
PrissyPotts

65 Ford Falcon won't turn over :(

I have a 65 Ford Falcon that tries to start, meaning the starter works but then it won't turn over. I just installed a new manifold and carburetor and she won't start. Any ideas why? I have already checked the plugs, fuel and the carburetor is brand new. One thing I will mention when the car stopped..
30
2014/02/23 18:55:16
sss1600

Ford Escort mechanics in Adelaide, SA? Rally and race prep??

Hi guys and girls, Im wondering if anyone could recommend a workshop/mechanic here in Adelaide (prefer south of cbd) where my mate could take his mk2 escort 2dr to finish off his brake lines, remote reservoir mounting and brake bias setup (adj pedal box), fuel system mounting (plumbing of surge tank..
3
2014/02/20 15:31:22
wade

32/36 dgav accelerator pump not working

I seem to be having no fuel getting pumped down the carb on my 2l escort its a fresh motor and I have put a kit through the carb but the accelerator pump appears not to work. The pump is new and I have pulled it apart to make sure there is no tears or holes and it has been correctly installed there ..
8
2014/02/14 18:59:35
jpayne

Adelaide, Flywheel machining

OK guys I need some advise/recommendations on flywheel machining places.Anyone done it recently and can give a heads up on who does it and what it cost. Need to get the tow ute done.central if possible...Easier to ask here that ring around at this stage. Plus posts are good for forums! JP..
2
2014/02/09 10:38:24

<< ..19 20 21 .. - Powered by APG vNext Trial

© 2025 APG vNext Trial Version 5.1

Use My Existing Forum Account

Username: Password: Verification:

Use My Social Media Account