Help... URGENT!

To Bottom

Help... URGENT! (p.109)
Post New Thread
Regular
camo91

heaps and heaps of questions

1. What size exhaust should i go with to get the best power? 2. Installing a cannon exhaust is a great way to get loudness but lose power? ture/false 3. How do I install a tacho into a mk 1600 escort? 4. I have a couple of digital LED guages but they are really bright a night( interfers with driv..
4
2010/08/25 13:57:31
Weiry

Gear Shift Boot

Hi Guys, Trying to find a Vinyl/Leather gear level cover to suit Escort Mk2 Console. Can any one recommend a "off the Shelf Version". Thanks, John..
12
2010/08/24 15:14:41
BryanS81

Speedo Cable....???

Hey guys the dumb questions will begin! For a Type 9 to RS dash is the speedo cable any different to normal? Where about would i get one from? Also the gearing for the speedo is out about 30-40kms so looking at changing the gear-drive for it where would i source them from? Cheers Bryan..
4
2010/08/23 20:01:10
camo91

lowering blocks

Hi everyone once again. I would like to lower the back end of my escort but have been told blocks that i order in from Autopro are going to cost me $109.55. Now to me that is too much, but what I have been asking myself,are most lowering blocks universal?? Would I be better to hit up ebay and go fro..
10
2010/08/23 19:47:26
ratta tat tat

Mk1 escort- coil spring problems :-(

So I've put Lovells springs in the front of my esky. I noticed when I pulled out the standard springs, that the top seats were both damaged where the straight cut on the piston shaft aligns with the seat. So damaged in fact, that the piston shaft was unable to locate back into the top seats. So I ca..
1
2010/08/23 14:50:43
Luke

Recommend me some filters

what's the suggested fuel filtes to use for efi. The facet has a inbuilt one but dont really want to rely on that. I was planning to put one pre lift pump then one between the swirl pot and the high pressure pump. I will be using braided lines if that makes much difference. Cheers..

2010/08/21 18:41:29
RS 2000

Rear Spoiler, RS 2000 badge

Hi Just wandering if anyone has measurements for drilling 4 holes in mk 2 Escort bootlid to fit the bootlid spoiler? Or if someone could measure theirs? Even if it is just one of the end holes with measurements from edges of the bootlid. Also I am chasing RS2000 nose cone FORD badge/lettering. Thes..
3
2010/08/20 02:21:05
2lt_Scort

Anyone a IPRA forum member?

I can't sign up to IPRA as I'm not an IPRA member or racer but I'd like to contact a seller on the forum. If anyone is a member can you help me out and see if a mobile number or email is in this seller profile? http://www.ipraforum.com.au/viewtopic.php?f=8&t=6388 Cheers, Rhys..
4
2010/08/19 21:58:43
DRS 02L

sierra 5 speed

what do you goys do when you cut the rectangle out with the cross member in a mk 2?..
4
2010/08/17 21:07:03
robertverhey

Need a car moved Botany to Five Dock, Sydney

Hi can anyone recommend a reasonably priced, reliable tow truck company that can move a car from Port Botany to Five Dock, about 20km, early next week? Thanks..
5
2010/08/17 19:12:52

<< ..109 110 111 .. - Powered by APG vNext Trial

© 2025 APG vNext Trial Version 5.1

Use My Existing Forum Account

Username: Password: Verification:

Use My Social Media Account