Gearboxes and Differentials

To Bottom

Gearboxes and Differentials (p.4)
Post New Thread
Regular
Suttonmotorsport

RX8 output shaft dimensions

Hi all,You would think that the info I require would be easy to come by but I haven't found it yet so hence my post.So what am I looking for?I am after the dimensions for the RX 8 gearbox output shaft.Diameter and the number of splines.Any help would be greatly appreciated. CheersCraig..
3
2018/03/13 18:26:10
Eskie92

MK1 Escort Sedan/Van Diff Differences

Hi everyone, I'm in need of new rear wheel bearings but when I look on Ebay they advertise Sedan and Vans as being different. Can anyone shine some light on this?..
4
2018/02/25 23:32:34
BEE VEE

CORTINA/ESCORT 4 SP TRANSMISSION EXCHANGE FOR 1972 CAPRI GTV6 PARTS

Hi all,those of you who know will identify this Gearbox for Kent or Pinto. I was told it is very low mileage and in very goodcondition. It comes with Shifter and Bell Housing, as well as Throw Out Fork. I cannot detect any wear and tear on any of the above from the outside. I have not yet examined i..
1
2017/09/11 10:24:47
danmk1

Sierra 5sp

Anyone have idea what T9 gearboxes are going for? Nothing wrong with mine except wanting to convert back to auto. Not the greatest box behind a 1.3l. Got this box a while ago and cannot find any on ebay/gumtree So dont really know value...
6
2017/06/18 21:29:14
griezy

4spd is hard to get into gear when warmed up, 2ltr escort van

hi guys, just a quick question, lately my 4spd box is getting harder and harder to select 2nd gear and some times 3rd only when the car as warmed up, not cold, been like this for about two years, i don't drive it much, probably 5000 in the two years, just getting a lot worst lately, would it need a ..
5
2017/02/20 23:07:08
gtv6capri

Celica 5 speed shifter help please

Hi all Im doing a Toyota 5 speed conversion, I have installed the gearbox and found the stick too far forward. No problem, I bought a cast gear stick extension to relocate it. The housing cam with a lengthened sleeve which attaches to the selector shaft by roll pin. I need to remove the existing sle..
2
2017/01/03 18:47:14
ed

Rear wheel bearing location in diff housing sandblasted and rough

Calling thinkers - obscure issue below. Iv'e had my mk2 escort diff housing sand blasted.The guy blasted inside the housing where the outer of the rear wheel bearings locate. It is very rough (as expected if sand blasted). Is there any reason to get it smoothed out?Will the o ring around the bearing..
4
2016/11/27 20:57:38
retro666

Quick shifter repairs?

Hi, Just had the nylon ball on my RS2000 shifter collapse, made a mess of shattered nylon to clean up and the gearstick to pop out. Was fun finding gears on the way home. Can the nylon parts be replaced and how does the gearshift come apart? Thanks...
9
2016/11/14 14:58:09
taylor1

LSD Center

Has anyone seen a Center like this before? I was told it will fit a 2l escort diff but I'm not so sure. Thanks Taylor...
4
2016/09/04 21:51:46
Suttonmotorsport

RX7 vs RX8 tailshaft differences

Hi All, As the topic says, what are the differences between S5 RX7 and RX8 gearbox tailshafts?I am aware that the RX8 is carbon fibre but am interested if the S5 RX7 tailshaft shares the same number of splines and the same O.D diameter? ThanksCraig..
4
2016/07/15 17:27:56

<< ..4 5 6 .. - Powered by APG vNext Trial

© 2025 APG vNext Trial Version 5.1

Use My Existing Forum Account

Username: Password: Verification:

Use My Social Media Account