General Sierra Discussions

To Bottom

General Sierra Discussions (p.2)
Post New Thread
Regular
markrs

WTB - 3DR Alloy Wheel Center Locks or Caps

Hi Guys, Chasing the following parts. 1) two, three or four alloy wheel center cap "locks", just the locks. 2) two, three or four center caps in good nick with or without locks. Cheers Mark...

2012/04/20 12:27:32
cswth1

rs500 update

Ok guys it has been a bit quiet on this site for a while so I reckon that it is time that I updated you on the RS500. I have changed the suspension and I am now running on brand new Gaz coilovers, fully adjustable for height and damping. I am very happy with them and it is nice to be able to tweak t..
2
2012/04/20 04:46:16
keithscossie

what tyres ??

My 3dr is still running on original tyres, well 10 year old but still the original types. As it stood on them for 10 years without being used I'm somewhat concerned about them ageing and peeling off on the first high speed track corner !! I'm looking for a recommended tyre to replace them with, wi..
7
2012/04/18 14:01:20
BLUOVL

4x4 Propshaft help needed

Gentlemen, I have an early 4x4 two piece propshaft. The hexagonal thick donut type. It is seized at the splines. I think the splines are twisted as penetrine and a hammer will not budge it. Could anyone provide the length of the male spline measured from the centre of the yolk or from the forwar..
2
2012/01/29 13:37:22
ossie cossie

Dick Johnson sierra found DJR2

On a UK website the Dick Johnson Racing sierra DJR2 has been found in the UK. Check out the thread. http://passionford.com/forum/general-car-related-discussion/417387-the-missing-dick-johnson-rs500-race-car-piccs-up.html Hope this works for you guys. You may have to log in to view pics. Keep the l..
1
2012/01/24 11:10:17
cswth1

rs500 passed

After converting everything back to the original standard the car has passed the regency test and will now go onto S.A. rego plates (FRS 500) so I wanted to thank all the guys who have helped with the parts and info I needed to get it to this stage. I hope you and your families, all have a great Chr..
3
2012/01/09 15:52:38
blackmk1cossie

l6 ecu

I am after an l6 ecu from 2wd saph. can anyone help..
3
2012/01/03 09:55:56
jeff

ford sapphire 2.0 gli starting problem pinto engine

hi all my first time all im new and am looking desperatley for some help i own a 91 ford sapphire 2.0 gli, it gives me a starting problem in the mornings she starts up fine a runs well apart from a sometimes erratic idle or high idle but after a short run she wont start up she has a very powerful sw..
16
2011/11/10 15:34:47
clevocapri

2wd Starter motor

Hi people. Does anyone know of a localy available starter motor for a 2wd sierra cosworth? I have the std Bosch one in at the moment. I think mines starting to die! Cheers Brett..
7
2011/11/10 09:18:42
Big_Gav

Front suspension...

Hi guys, I have finally got around to finishing the front of my Sierra. I have installed CompBrake adjustable TCA's and CompBrake adjustable compression struts. I have taken out the roll bar to use the mounting points for the compression struts. My question is... What happens with the roll bar now? ..
5
2011/10/27 15:52:09

1 2 3 .. - Powered by APG vNext Trial

© 2025 APG vNext Trial Version 5.1

Use My Existing Forum Account

Username: Password: Verification:

Use My Social Media Account