2013/06/01 09:22:44
smallvan
I was browsing Ebay ,and found this and had a light bulb moment.
http://www.ebay.com.au/itm/BLUE-80MM-THROTTLE-BODY-PERFORMANCE-INTAKE-MANIFOLD-BILLET-ALUMINUM-HIGH-FLOW/111040761009?_trksid=p5197.m1992&_trkparms=aid%3D111000%26algo%3DREC.CURRENT%26ao%3D1%26asc%3D14%26meid%3D8056537271615480340%26pid%3D100015%26prg%3D1006%26rk%3D1%26sd%3D111040761009%26
Could i get this working on my kent motor,Would it work and what would you need to do it.
2013/06/01 09:50:52
gtv6capri
How close is the ford KA intake manifold to the Kent?, the engines look remarkably similar.  I see a few KA's in local wreckers, maybe you could use that as a base
2013/06/01 10:26:50
escortinadriver
That is for the throttle body only.
 
You will still need to make a manifold, with injectors, get a loom, fuel pump and and ecu to run the thing at a minimum.
 
You would be better of adapting something else.
 
Shaun
2013/06/03 22:14:25
spigot
80mm is way too big for a Kent motor. Those throttle bodies whilst ok quality do not use a non-linear linkage rate which is mandatory on a small motor. 60mm is about the biggest you will want.

© 2025 APG vNext Trial Version 5.1

Use My Existing Forum Account

Use My Social Media Account