the black circle is pen, i did the whole car to show me where all the dents are so when i sand it down and gets covered with dust, i can see where i need to strip back to bare metal to bog, all dents are pressure dents from people leaning on the car no hits apart from passenger side front gaurd
 
also about the fuel caps EH holden fit perfectly, that pic is a old one i have now got a larger cap from a EH to fill in the spill tray and no leaks

I have the same problem with pressure dints, not one panel missed. Also they must have been heavy as there big. I like the wheel treatment, clean and old school.

thanks mate, i have sold those wheels since that picture, they were 15in Saab wheels, i have now got four spoke dragways and BF Goodrich tyres, 14in rear 13in fronts
 
 

The dragways are nice as well with spinners. I just found another leak, this time there is a plastic plug on one end of the tank up near the top. Its leaking out when filled, got another tank without this and will be changing it over tomorrow. 

Changed the tank but still have problems. The replacement is a bit rough inside and the sender is frozen. So looking for a tank in clean condition, anyone got one they don't need.

griezy
this is what ive done,

 
ive put a XR - XY Falcon spill tray

Hey Griezy, where'd you find the spill tray. I've got a CPC SL19 cap on the van, but the tray would be cool too. I can't seem to find who makes them.

I think I have sorted it out until I change the filler cap. Changed the fuel cap, it was leaking through the key hole on a locking cap. Also fitted a later tank and redone the venting to what I thought it should be. Now when I find a hidden filler from a doner car it should be ok. Its had a hit at the filler area and badly repaired so about 1/3 of the quarter needs repair.