Guys I have found the lower bulkhead I need, It is attached to a complete A pillar cut so I'm offering for sale the left over parts. these are the upper bulkhead, heater bubble, cowl and dash panel (which I will confirm condition upon stripping) front outer sill corners and probably most of the splash panel and A pillar door posts. I think the windscreen wiper mechanism is there too
I bought this because it all appears rust free, is straight and also was available.

Obviously parts are still attached to one another but if people want/need parts I will remove them by drilling out the spot welds where necessary or cutting through the adjacent panel as possible.






Parts are in Adelaide but I am happy to have collected by buyers courier or drop at the post office at buyers cost for smaller parts.
Let me know what interest there is and we can negotiate price upon review of required part. I am happy to photo particular parts during discussions.
Cheers
Justin
 
 

comes with cruise control actuator? must have been the luxury model  
 good luck with sale
 
cheers

What would the heater bubble cost me? I'm in Adelaide's Southern Suburb's.
Cheers

Ajax,
Im thinking circa 75 bucks for the heater bubble.
and for anyone else
100 for the upper bulkhead
75 for the central lower bulkhead (transmission tunnel to bulkhead lip
50 per scuttle corner/windscreen corner
75 for the dash panel
50 for each sill leading edge.
75 for each lower A pillar including door hinges
20 for the remainder of each splash panel.
Prices negotiable of course
Of course each panel needs to be removed which I will start this weekend and prices can be confirmed once we have the part to view properly.
Cheers
 
Justin
 

No worries Justin,
 
Could you let me know when it becomes available and I can come and have a look, consider it sold if in good condition.
 
Will need to know an address to come and view.
 
Cheers Paul

cheers Paul.
Ill post up here or PM when it's off
 
Justin

Ill take the passengers side scuttle / windscreen corner piece and the drivers side lower a pillar/ hinge post

Hi Justin, 
i need a heater bubble, and the panel below, that it is attached to, from inside guard to inside guard,
i'm sure i can pickup a heater bubble, as ajax has put his hand up for yours. 
Happy Drilling, Geoff, … (newby) 
is it the Upper Bulkhead.???
I'm getting my head around, the mammoth task you've undertaken.!!
I have a Spot Weld Cutter, that may help, call or PM and i'll get it to you.

Ok Guys, Ill get photos of the parts up when I start the spot weld drilling marathon. It was 50 in the shed this last weekend so not going near it then.
Give me some time and hopefully all parts will be useable.
Parts will be offered to first in, so far only the bubble is multi-requested...
Cheers
 
JP

Hi, JP  … I'd love the upper bulkhead, if that's the panel where the bowl attaches,
from inside guard, to inside guard, … i have a spotweld cutter with 6 double ended 
cutters, happy to send to you, if it makes life easier, (which you are probably using)
call if you think it may help, and i'll post it to you, asap express
cheers Geoff,   … … I'm in a no rush situation,
 
We're just a bit toey here, we have d**kheads lighting fires.!! …