Hi all,
I don't know much about clutches however when I saw the clutch my engine builder is going to install I was a little suprised at how flimsy it looked for a flywheel thats gonna get approx 400hp chucked at it.

wouldn't mind your thoughts here as I'm open to spending the right cash for the right setup.

Looks like a light switch, to me.

[on/off]



with springs.

[cushions]

Now that confusing.

http://www.exedy.com.au/ButtonClutchKit.aspx

That looks like the one. What are you using the car for?

http://www.exedy.com.au/TechVideos.aspx

The two tech videos are interesting.

Hi Muzza,

As long as the pressure plate is set up properly it should be fine...only marginally more aggressive than a standard heavy duty type. I've run a 5 button sprung centre set up for years without issue.

Cheers,

Phil.

Ahh Cheers Guys! Just that I had a carbon one installed previously and it had alot more contact surface on it, Phil if your using the same then I guess I shouldn't have a problem with mine. The wheels would spin before the clutch slips i guess!