hi, went to fit my fuel pump yesterday and seen that the pump push rod was missing, anyone got one, or have the dimensions for one thanks

this is the one that sits in the block

HI,
 
Had the same thing happen to me, found the my original one was to corroded and misshapen to use again.  If you have a good quality set of  allen keys the 6mm one is exactly the right dimensions- however I can't tell you the length as I had the old one to measure against when I cut the allen key down to size. The good quality ones are tempered steel - the cheapies are just mild steel. Maybe someone an give you the length.
 
Cheers,
 
Len

I have one if you are stuck in Melb.
 
Has some surface rust but will clean up fine with some wet and dry.
 
NQRS are you thinking of the Oil pump drive as that is hex and the fuel pump is round?
 
Cheers,
 
Matt

Thanks, Matt- you're correct- the hex one is for the oil pump.  Just for anyone out there if you do lose one- I found my old one and it is 60mm long.
 
Cheers,
Len