A car I just brought has one on it

Todays update.  Left rear quarter repair section attached, a few patches to the wheel tub and arch.  Valance arrived looks good 

Ex-Pressed Valance Skin 

You bodywork looks really nice.
 
Those Ex-pressed panels seem to be well made, how do you find the fit?

Fit is very good, not a direct fit still a little bit of fettling but the large areas are uniformly smooth.  Ex-Pressed us a heavier gauge steel than the other parts available so the distortion once welded is less 

Small repair section that took a long time to complete.  This section rusted away allowing water into the boot, which caused the lower section to rust.  I have seen a lot of cars go n this place, the repair is beautiful.  I am reliably informed that taillight and beaver panel are ready for installation.  Wheel arches had been cut and folded for clearance, My fabricator felt it better to undo the modification rather than fit a new arch due to the length of weld needed.   

Just collected the re-trimmed seats for the old girl.  The car was delivered with B2 trim code, the rear seat was still in the car but the front seats were long gone.  I located a pair of high back buckets and had them re-trimmed using the correct Ford cloth which is kind of like hessian.  They came up very well and look the part.  I think this was an important part of the car to retain

What style high back. Knob at bottom or 3/4 up the side. They look the part. Well done

Is that Betacloth, like they have in Escorts? looks similar. Len

Typical english locks.............bootlid lock works fine; BUT WITH ANY KEY AT ALL !!!!!.......great!