Im the same im about to completely re wire the whole car using an EZ wire kit
Plus haltec ps2000 for the engine side of things

hey lads, 
 
just got my mk2 with sr20 on the road. i had been holding off redoing the boost piping untill it was on the road. while im at it im wanting to fit a bigger intercooler. its only got a small rx7 one fitted at the moment.   just wondering what size others are running and how much cutting is required to fit.  its a flat front mk2 and it looks as though ill have to trim the panel under the bonnet catch and re inforce it.  any advice would be great
 
cheers

pretty sure mine is about 480mm wide and 360ish tall
 

 

 

 
just an ebay cheapy

i didnt have too trim too much only the cooler pipe holes, and just below the bonnet latch, but  on mine we reinforced the slam panel, you can also see where the locating tabs have been added and teh slam panel reinforcement.  
i think im running a cooler one size down from mish's and the other way around do the outlets are at the bottom.
This might suit an SR as the turbo is low,
 





your welcome to come have a look if you like, you could also show graeme your diff.
 

thanks guys. im getting one made up to fit nicely without too much cutting. 

Anyone after a x-member to fit the SR...
 
http://www.ebay.com.au/itm/Ford-Escort-Sr20-Cross-Member-/291109720793?pt=AU_Car_Parts_Accessories&hash=item43c77dd2d9