Hi all
 
I have recently changed my cluster over to a tacco ghia one and i have everything working fine. My only problem is the tacco itself. it works fine but when you blip the throttle it shows the needle go way up the tacco and 'bounces' back down? i have an aftermarket one i was using still hooked up and it goes up and down fine, and when i disconnect the aftermarket onethe factory tacco still is 'bouncy' is this just a stuffed tacco or something that is adjustable?
 
Cheers
Matty

Matty,
 
I had this issue and it was just that the needle was loose on the shaft.
 
I ended up just pushing it on a bit harder by hand and the problem was fixed.
 
It's often the most simple of fixes.
 
Good luck.
 
Matt

Ah righto thanks matt.. so pull the cluster out and remove the tacco section and press the white needle down harder onto the shaft and that should hopefully fix it?
 
Ill give it a go!
 
hope this is a simple fix to :)
 
Oh did u ever get those emails of my brakes? i emailed heaps to you but didnt hear anything back
 
Cheers
Matty

Hi Mate,
 
Yeah, just pull it out and do as you described.
 
My memory is crap so I can;t remember getting the photos but not to say I didn't.  If tyiou can be arsed please send them through again.
 
Cheers
 
Matt
 
 

Gave up and put my aftermarket Tacco in the original wouldn't stop bouncing..

Looks good Matty!