Will these wheels fit my bubble arch mk1

The wheel sizes are:
2 wheels 13" X 10" (rear)
2 wheels 13" X 8 1/2" (front)

Inner offsets are:
2 wheels have offsets of 142mm
2 wheels have offsets of 118mm
Measured from the inside of the centre hub to the
outside of the outer hub.

By the nil response to your last post I suggest this is the only reply to this post.

The rears probably won't fit unless you shorten the diff assembly. If you are intending to register the vehicle then forget wheels that wide. You will most likely not legally get away with wheels anything more than 50mm wider than than the standard wheels fitted to the vehicle.

does that mean if i have 8 inch wide wheels as standard i can legally go to 9 inch wide. sorry to steal your thread.
However here is a pic from a uk site, it has 10 inchers on.

Ick they look like they should be on something from jap land. Stretched rubber just doesn't look right.

I have a couple of mates in the UK and they tell me you can practically get away with anything over there. Read the standards that apply in your state; adopt them and you won't have trouble with the law. If you want to get away with anything, move to South Australia. You can pass rusty vehicles off as rust free and even use coke cans to join the exhaust together and still get the thing registered.