Looking for the fitting that screws into the block. Has anyone got one they want to sell or can lend me to get one machined up. I am in Melbourne.

John
0419 159 893

I am assuming you have the original line and looking for the fitting that goes between the line and the block? If so, you may be able to pick one up from a speed shop. If i recall correct, the size going into the block is 1/4 ntp. I got one recently to hook up a aftermarket line and secondary electronic gauge.

Yep, that's what i need. What speed shop did you get it from?

John

I have a "T" piece that allows fitting of a mechanical pressure gauge and the std pressure switch. You can have it if it's what you need.

Cam

I got it from outlaw speed shop in Adelaide. Try looking up someone other than supercheap and repco who sells high end modification gear, eg blowers etc and they will usually stock braided lines and associated fittings and you'll probabally be on a winner.

i used a Swaglok right angle fitting . 1/4npt thread with a 1/4" olive other end.

What does everyone use to fitting these threads so they dont leak? Some sort of thread tape?

Don't reuse the collars that clamp the oil line under the olive.

You may want to consider a sandwich plate! there are heaps on ebay

Thanks Geoff Wade for sample. Off course mine was a different thread, got one turned up in lathe so all good.